When assigning a mount point folder path to a drive, use Event Viewer to check the system log for any Cluster service errors or warnings indicating mount point folder path failures.You cannot modify the mount point folder path directly. To modify a mount point folder path, remove it, and then create a new folder path using the new location. ![]() Mount point folder paths are available only on empty folders on basic or dynamic NTFS volumes.If you are administering a local or remote computer, you can browse NTFS folders on that computer.Specifies an empty, existing NTFS folder where the mounted drive will reside. In addition, you cannot assign a drive letter to an Original Equipment Manufacturer (OEM) partition, EFI system partition, or any GPT partition other than a basic data partition. You cannot assign drive letters to boot volumes, or volumes that contain the paging file.Using the assign command, you can change the drive letter associated with a removable drive.If the drive letter or mount point folder path is already in use, an error is generated. If no drive letter or mount point folder path is specified, then the next available drive letter is assigned. Assigns a drive letter or mount point folder path to the volume with focus.On a basic disk, selecting a volume also gives the corresponding partition focus. You can specify the volume by number, drive letter, or mount point folder path. If no volume is specified, the select command lists the current volume with focus. Selects the specified volume, where volumenumber is the volume number, and gives it focus. Select the folder from the list, and then select Remove.ĭisplays a list of basic and dynamic volumes on all disks.Select and hold (or right-click) the drive mounted to a folder, and then select Change Drive Letters and Paths.To remove the mount point so that the drive is no longer accessible via a folder: To mount a drive in an empty folder using a command lineĪt the DISKPART prompt, type list volume, making note of the volume number you want to assign the path to.Īt the DISKPART prompt, type select volume, specifying the volume number that you want to assign the path to.Īt the DISKPART prompt, type assign. Type the path to an empty folder on an NTFS volume, or click Browse to locate it.Click Mount in the following empty NTFS folder.Click Change Drive Letter and Paths and then click Add. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |